News:
Need a Budget Carb Rebuild Kit? Check out our $45.95 SR Kits. Same Top Quality Parts as the Full Kits.
| Subject / Started by | Replies / Views  |
Last post | ||
|---|---|---|---|---|
|
|
Idle-system
Started by Marx3 |
3 Replies
2973 Views |
April 02, 2010, 03:39:00 AMby Cliff Ruggles |
|
|
|
newbie seeking advice
Started by murph3204 |
3 Replies
2972 Views |
November 27, 2010, 04:17:59 AM by Cliff Ruggles |
|
|
|
5 Replies
2972 Views |
September 28, 2012, 02:58:29 AM by Cliff Ruggles |
|
|
|
|
Copper on gaskets?
Started by Toronado |
3 Replies
2970 Views |
April 04, 2011, 07:50:40 PM by billy 2 |
|
|
0 Replies
2969 Views |
November 23, 2009, 08:35:24 AM by jamesF |
|
|
|
|
Fuel pump install
Started by Mark R |
1 Replies
2968 Views |
October 11, 2009, 10:54:52 AM by omaha |
|
|
|
secondary metering rod hangers
Started by horsepowerfreek |
3 Replies
2968 Views |
February 08, 2012, 09:49:01 PM by Ethan1 |
|
|
|
Duplicating the teflon green plating.
Started by Spudboy |
5 Replies
2962 Views |
June 12, 2016, 05:24:43 PM by Ethan1 |
|
|
|
Port letters on Q-Jet housing
Started by johngaltx |
2 Replies
2960 Views |
May 19, 2010, 01:20:53 PM by johngaltx |
|
|
|
Unmarked Metering Rods
Started by cobalt327 |
1 Replies
2959 Views |
March 19, 2011, 05:19:07 AM by Cliff Ruggles |
|
|
|
Special Thanks to Cliff
Started by Mr.Pontiac |
2 Replies
2958 Views |
November 04, 2009, 08:01:48 AM by Mr.Pontiac |
|
|
|
Secondaries sticking
Started by Warriorautotech |
9 Replies
2957 Views |
November 01, 2018, 04:21:18 AM by Cliff Ruggles |
|
|
|
Adding ported vacuum
Started by Zac Agee |
3 Replies
2956 Views |
July 31, 2012, 03:15:15 AM by Cliff Ruggles |
|
|
|
5 Replies
2955 Views |
February 04, 2016, 03:14:00 AM by Cliff Ruggles |
|
|
|
|
Rod hanger 'G' or higher?
Started by dayzedandkonfuzed |
2 Replies
2953 Views |
February 27, 2013, 05:07:12 AM by Cliff Ruggles |
|
|
Carb Nomenclature With Pictures
Started by WideTrack |
12 Replies
2948 Views |
April 30, 2020, 08:31:11 PM by qjetsrule |
|
|
|
primary throttle shaft
Started by Michael9040 |
2 Replies
2946 Views |
August 16, 2010, 04:21:12 AM by Cliff Ruggles |
|
|
|
7 Replies
2943 Views |
September 30, 2017, 03:06:58 AM by Cliff Ruggles |
|
|
|
|
Why front inlet and side inlet?
Started by jamesF |
2 Replies
2942 Views |
December 31, 2011, 06:26:08 PM by Ethan1 |
|
|
|
carb to tank?
Started by Toronado |
4 Replies
2940 Views |
April 09, 2011, 03:22:35 AM by Toronado |
Normal Topic
Hot Topic (More than 10 replies)
Very Hot Topic (More than 20 replies)
Locked Topic
Sticky Topic
Poll