« previous next »
Pages: [1]   Go Down

Author Topic: Question about resizing main bleeds  (Read 2970 times)

Offline 73 Z28

  • Carb lover
  • ***
  • Posts: 73
Question about resizing main bleeds
« on: April 15, 2009, 05:49:03 PM »
I have harvested some brass restrictions from some parts carbs and was wondering if I can just drive them into place with a hammer and punch or do I need to epoxy them to ?

Thanks for any help with this
Paul
Logged

Offline jxu109

  • Garage guy
  • **
  • Posts: 28
Re: Question about resizing main bleeds
« Reply #1 on: April 15, 2009, 06:14:32 PM »
I did the same thing to my air horn, and busted the main bleed in the air horn... I think they sell some sort of screw-in deal you can use rather than hammering something into your carb.  I found out the hard way you gotta be very careful...  ;D
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5435
Re: Question about resizing main bleeds
« Reply #2 on: April 28, 2009, 05:20:55 AM »
We have screw in main airbleeds as they have discontinued the pressed in variety many years ago.  I contracted to have some made, and they are supposed to be here this week, so we should have both styles available soon.....Cliff
Logged
Pages: [1]   Go Up
« previous next »