General Category > Quadrajet Carb Talk and Tips

Bent my primary metering rod arm

(1/1)

Dark T/A:
in the process of tearing down my carb and following Cliff's book. I tried to be as careful as i could but manage to pry too much and one side of the piston and is now tweaked. What do I do replace it or bend it back??

Shark Racer:
Bend it back, just take some measurements to make sure the eyelet of each arm is roughly the same distance to the bowl or other reference points.

Dark T/A:
thanks its not too bad shouldnt take much

Navigation

[0] Message Index