Quadrajet Problem Solving > Diagnose a Quadrajet carburetor problem

Missing Vacuum Port? what do i do?

<< < (3/5) > >>

72Campcust:

--- Quote from: Cliff Ruggles on February 09, 2013, 03:38:49 AM ---Just remove the two long screws in the back and the screws holding the baseplate to the main casting, it will come right off for repairs/modifications....Cliff

--- End quote ---

Thanks for the help..hopefully the last question..

Pulled apart..now..which hole do i plug with epoxy??
Top right is the vacuum port i was using, this is view from top


this is bottom side of it..

72Campcust:
TTT...

Cliff Ruggles:
The round hole just aft of the flat slot is the bleed off hole....Cliff

72Campcust:

--- Quote from: Cliff Ruggles on February 17, 2013, 05:42:53 AM ---The round hole just aft of the flat slot is the bleed off hole....Cliff

--- End quote ---

Thanks... Im guessing you mean this hole..(where the pencil is)

Cliff Ruggles:
The round hole inside the bore just aft of the slot that provides ported vacuum.....Cliff

Navigation

[0] Message Index

[#] Next page

[*] Previous page