Quadrajet Problem Solving > Buy Quadrajet Parts, Quadrajet Kits, Service

Hay Cliff how do you remove secon. emus. tubes???

(1/1)

Mr.Pontiac:
The brass tubes in rear of carb. i call em emulsification tubes, i heat carb. up to pull em out and they get stubborn sometimes, how do you remove them??? I see you can buy brass stock tubes same o.d and i.d. but using a tubing cutter always leaves a burr, are you doing this also???

Shark Racer:
If you get a burr, head over to a good gun shop, they sell deburring tools or reloaders that will put a nice clean chamfer on them for a couple of bucks.

Cliff Ruggles:
Never once had any trouble pulling them out with a small pair of wire cutters.  I warm up the casting around them for a few seconds with a propane torque.  Since we change the plastic cam on all builds, no risk of melting it....Cliff

Mr.Pontiac:
Thats what im using but always gets a tiny burr close to the casting area, no biggy just wondering.

Navigation

[0] Message Index