General Category > Quadrajet Carb Talk and Tips

Jet and rod recommendations for a 350

<< < (2/2)

BoxWagon:
I would assume lean as well.  I guess I might just have to use this setup and experiment.  I wanted to avoid taking it back apart if possible.  I know all engines run differently even if they are technically the same engine, but I figured I wasn't the first person to need a starting point for the ultra-rare Chevy 350/quadrajet setup.

As for the air bleeds, I wish I knew.  They are whatever the original ones to the carb are.  Sorry, its not helpful, I know.         

Shark Racer:
You can probably size them using one of those $10-20 drill bit kits... the stock ones on most of my late 70's Chevy carbs are just under 1/8".

Cliff Ruggles:
The stock 50M rods are fine.  I'd install 74 jets with them.  DP secondaries are OK for a stock build.  If headers or dual exhaust are added, I'd install smaller secondary metering rods as well....Cliff

BoxWagon:
Thanks for the help guys.  I'll adjust according once its running. 

Navigation

[0] Message Index

[*] Previous page