General Category > Lobby

copy cad plating kit

<< < (2/2)

Shark Racer:
I haven't tried it yet. I did glass which did a great job. Soda is a little softer and dissolves in water so you're less likely to clog a port. I may try it out this weekend.

As far as compatibility goes, glass should be fine. Just have to give everything a good clean.

Ethan1:
 I actually prefer soda blasting. Does a great job. :)

hunter55:
I've never used soda and just recently switched from coal slag to glass bead because I knew the coal slag would be to agressive for the die cast carb bodies.  I did notice on a very humid day that the glass bead is hydroscopic and got to where it wouldn't slide back down the sides of the cabinet very well to the pick up tube.  The next time I used the blaster,  the humidity was back down and the media was back to normal.  I just wonder if the soda would have the same tendancy or maybe even be worse.  Has anyone experienced this happening?

Shark Racer:
Soda will definitely take on humidity.

Navigation

[0] Message Index

[*] Previous page