Quadrajet Problem Solving > Quadrajet Parts and Numbers

17084226

<< < (2/2)

TommyK:

--- Quote from: Shark Racer on April 22, 2013, 06:11:18 PM ---Looks like DP and EH rods are identical (on my source, anyways).

Are you positive you're running 51M? If you're running an 026 tip rod (K/J and others) you'll go quite rich.

Are any of your air bleeds blocked?

Any chance the power piston arms are bent up and the rods are not even in the jets?

--- End quote ---

I will double check the rods but the originals were 51M and I reused them. It had 72 jets in it when I pulled it apart. Thought it would be lean so I put some 74 jets in I got from Cliff a while back along with the orange power piston spring. I can check the movement of the power piston through the APT hole tonight but the A/F gauge suggests it is working. Last thing I did Sunday was adjust the APT from 3.5 turns down to 2.5 turns but I haven't had a chance to test drive it yet. I checked the secondary hanger height last night and it was right around 41/64.

I just rebuilt the carb and ran drill bits through all the holes so nothing should be blocked.

I am going to lockout the secondaries and see if the issue is on the primary side.

Thanks.

Navigation

[0] Message Index

[*] Previous page