General Category > Quadrajet Carb Talk and Tips
carb advice please
Shark Racer:
Do you mean the secondary jets - at the rear of the float bowl?
kenn:
yes if there called jets ? Thay dont seem to screw in like the primarys.
429bbf:
the little discs in the back of the fuel bowl should be about .135 they do not come out .( im not saying you can take them out) leave them in. some times one will be a little out of round from the metering rods flopping around. they are not intended to seal .they just control the amount of fuel the 4 barrel gets , depending on the rod size and hanger length and secondary air flap opening .i hope im not confusing you .
kenn:
Thanks for input. That was my worry one of the holes is out of round. The hanger looks bent. I'll buy a new one (hanger)when I buy the kit. It sounds like it should be ok because the truck will be a daily driver.
kenn:
Hello. After thinking about it I cant get past the idea of leaving the secondarys like that. I'm going to find a different carb. Thanks All for the help.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version