General Category > Quadrajet Carb Talk and Tips

#6 steel braided line

<< < (2/3) > >>

Shark Racer:
Man, I must have been distracted yesterday. I assumed he meant the end of the fuel inlet fitting, not the front of the carb. D'oh!

Yeah, as others have said 1" or 7/8 NPT.

The fuel inlet fittings can be sourced through Cliff, I'm pretty sure. The OEM one with the steel line has the straight thread with flares that I mentioned.

fat tony:
thanks ethan1. that fitting is better than what i originally wanted. i was ready to modify a stock fuel inlet nut.
i found one. thanks again.
tony

dougbert:
Searched the site for this topic, finally found this thread

QUESTION: The -6 AN adapter that fits in the fuel inlet pictured on this thread, does it still allow the paper filter and spring to fit properly?

I have a fitting that won't allow that fit. The long filter and spring won't fit.

Do I have the wrong fitting?  Is there another that does allow the filter to fit?

thanks

doug

429bbf:
doug. if you have the fitting that is shown on this post (its hollow on the inside )then the long filter and spring will fit . if your fitting is flat where it screws in and just has a hole drilled in it you will have to use the short filter. hope this helps

Ethan1:

--- Quote from: 429bbf on April 19, 2014, 09:22:35 PM ---doug. if you have the fitting that is shown on this post (its hollow on the inside )then the long filter and spring will fit . if your fitting is flat where it screws in and just has a hole drilled in it you will have to use the short filter. hope this helps

--- End quote ---

 What he said. ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page