General Category > Quadrajet Carb Talk and Tips

Putting Carb back together

(1/2) > >>

58chev:
I have looked every where and cannot find ant torque value for the base plate, main body & air horn screws.  :-\

I figure at least not to gorilla wrench them down.  ;D

Is there a specific torque value, or just snug them down?

Ethan1:
 I would just snug them down. But, if you are looking for the correct torquing, it is 2 ft./lbs or 24 in./lbs. Also, make sure you torque them in the correct sequence. Just like torquing down a head, intake, etc. 8)

58chev:
Great ThanX

What about thread sealant, Should I put any on the screws?

Ethan1:

--- Quote from: 58chev on February 13, 2015, 03:47:51 PM ---Great ThanX

What about thread sealant, Should I put any on the screws?

--- End quote ---

 No thread sealant is needed.

58chev:
Got a part left over and can't figure where it should have went??




Hope it runs as good as it looks.  ;D   8)

Navigation

[0] Message Index

[#] Next page