Quadrajet Problem Solving > Dialing in your rebuilt Quadrajet carburetor
which holes to measure???
jbh7052:
the one with the drill bit...correct air bleed??? Do you see an air bleed in the air horn??
429bbf:
you are correct that is the upper idle air bleed. your main air bleed will be in the air horn .there should be 2 of them . its hard to see from the bottom of the air horn. if you flip it over and take another picture ill tell you what you got. fwiw
jbh7052:
here is the top side of the air horn. I received cliffs book today! Sweet! From looking at it i see the main air bleed but no idle bleed. hope i am starting to understand this!
429bbf:
yup your right on target. if the idle air bleeds were in the air horn on that vintage there would be 4 holes in the air horn . enjoy your reading , it is the best quadrajet book i have ever read because its real straight forward and give you a very good starting point . enjoy and welcome to chp.
jbh7052:
Thank you so much! Would like to shake your hand but this is all I got! I really appreciate your attention...you have help me a lot! I hope you have a great weekend! Thanks from Arkansas :D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version