General Category > Quadrajet Carb Talk and Tips

idle tube rod length matter???

(1/1)

Mr.Pontiac:
After pulling a set of idle tubes out the collars get buggered up sometimes. is it ok to touch them on a belt sander just enough to clean up ends of collars while still intact on the idle tubes???? Does the length actually mean anything???

429bbf:
i second the question I've done that also . doesn't seem to make a whole lot of difference. would like to know if somebody has tested this.

Cliff Ruggles:
It will not hurt or effect anything if they are a little shorter than the stock ones, the tubes extend well below the fuel level in the main bowl when the float is correctly adjusted.....Cliff

Navigation

[0] Message Index