« previous next »
Pages: [1]   Go Down

Author Topic: idle tube rod length matter???  (Read 1891 times)

Offline Mr.Pontiac

  • Qjet Hero
  • *****
  • Posts: 544
idle tube rod length matter???
« on: April 29, 2015, 10:34:11 AM »
After pulling a set of idle tubes out the collars get buggered up sometimes. is it ok to touch them on a belt sander just enough to clean up ends of collars while still intact on the idle tubes???? Does the length actually mean anything???
Logged

Offline 429bbf

  • Qjet Hero
  • *****
  • Posts: 539
Re: idle tube rod length matter???
« Reply #1 on: May 05, 2015, 07:31:55 PM »
i second the question I've done that also . doesn't seem to make a whole lot of difference. would like to know if somebody has tested this.
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5432
Re: idle tube rod length matter???
« Reply #2 on: May 10, 2015, 08:20:58 AM »
It will not hurt or effect anything if they are a little shorter than the stock ones, the tubes extend well below the fuel level in the main bowl when the float is correctly adjusted.....Cliff
Logged
Pages: [1]   Go Up
« previous next »