General Category > Quadrajet Carb Talk and Tips

Re Tapping idle mix holes

(1/1)

77cruiser:
Can that be done? I have a late one with the fine threads & one is messed up. I wanted to try the earlier style needles with the 10-32 threads.

Ethan1:

--- Quote from: 77cruiser on July 23, 2015, 07:46:47 AM ---Can that be done? I have a late one with the fine threads & one is messed up. I wanted to try the earlier style needles with the 10-32 threads.

--- End quote ---

 Probably could be done. I believe there at an angle, so it might be a little difficult, if you do not have good drill press. I would not do it by hand though, IMHO. If you are off just by a fraction, then either you can use it as a paper weight or throw it in the garbage. ;)

Navigation

[0] Message Index