General Category > Lobby
how do you know which castings are best to use
Wicked45:
New to the the forum i have a 17058213 that i was going to rebuild for a friends dirt car was wondering if this body is good or bad ? I ordered Cliff book just can wait for it. Thanks in advance all,the posts I have read are great.
carmantx:
Welcome to the group.
That's interesting, because I pulled a 17058213 apart today to build for a customer. It is a single MAB carb and APT in base which is not my favorite design, but certainly very functional.
As far as best design, it all depends on engine set up and tuning desire.
Wicked45:
do you you take out the apt in the base what the best way to adjust it?
Ethan1:
--- Quote from: Wicked45 on August 03, 2016, 09:37:11 AM ---do you you take out the apt in the base what the best way to adjust it?
--- End quote ---
Welcome to CHP!
Not my favorite design either. Also, I believe on that one, you have to drill out the plug to get to the APT screw. Another reason I do not like that design.
What are you building it for?
Wicked45:
Sorry I have been busy we build it for 350 30 over flat top 410 lift camshaft with 487 cylinder head the reason I was plan on using this body because i 3 of them and clean in good shape as cores plus I don't want to have to much carburetor
Navigation
[0] Message Index
[#] Next page
Go to full version