Quadrajet Problem Solving > Diagnose a Quadrajet carburetor problem

I'm guessing these fittings are not supposed to do this?

(1/1)

fumehappy:
So, Pulled my air cleaner to get the casting number to order a rebuild kit from Cliff's, and noticed that the brass fitting that is maybe my vacuum advance was just laying on the intake.   When I went to correct it, the vent hose/ canister hose on top simply slid out.  I fit both back in firmly, but unsure what that happened?

Thanks!

Jeffs68:
Those vacuum fittings do pop out once in a while, after you rebuild it and clean things up, you can take a center punch and stake them if you want.

77cruiser:
Once cleaned up you can use some Locktite I use red or green. That keeps them in place.

Navigation

[0] Message Index