Quadrajet Problem Solving > Dialing in your rebuilt Quadrajet carburetor

Carburetor setup for an newly installed HT383

<< < (2/2)

Cliff Ruggles:
DA rods should be fine with the lower hanger.  Do some testing and if you don't get any hesitation/stumble/bog after the tension spring is correctly set, leave the N hanger in place. 

I use an "L" hanger in my carb with the same DA metering rods and it is flawless going into the secondaries.  If I try taller hangers I get a little "burble" out of it on hot summer days from a momentary rich condition. 

Hope this helps some?.....Cliff

mkilmer402:
It definitely does help, Cliff.  Appreciate the advice.  As an engineer, I like to fiddle with stuff until I break it, then go back and fix it :P.  I think I'll play with the apt settings a bit more first before changing anything on the secondary side. 
Thanks again!!

Navigation

[0] Message Index

[*] Previous page