General Category > Lobby

Show Your Carb Tools

<< < (2/2)

Hillbillyenginering:
Ethan
I do have a number of tools. Just too lazy to head out to the shop to take picz.
The normal. Multiple drill index's, taps, extra small center punch, home made adjuster for APT from a 5/16 stainless bolt, two idle screw adjuster one is spring extension, a aluminum plate to hold the base for drilling And tapping. But I drilled a hole between the front primaries and threaded it. Made a special gasket for it. Hook up my industrial vacuum pump, hook up the A\C gauges with an old tank for more volume. I can test when the power piston starts to go up or down. Probably not a total he necessity, but as you can see from my user name I can get a bit excessive.lol
I tried to use it attached to my toro engine trying to find a leak that wasn't there. Should have made it from at least 1\2"

Ethan1:

--- Quote from: Ethan1 on January 27, 2017, 07:01:15 AM --- Here are my carburetor tools: (Hopefully they load with PB)

 

 

--- End quote ---

 Here are just my carter carb tools:

 

Navigation

[0] Message Index

[*] Previous page