General Category > Quadrajet Carb Talk and Tips

Newly Built 383 Stroker w/Quadrajet

<< < (5/6) > >>

77cruiser:
Once you get the idle tubes out it's a piece of cake. Do you have a set of small numbered drill bits?

ykf7b0:

--- Quote from: 77cruiser on September 05, 2017, 08:26:00 AM ---Once you get the idle tubes out it's a piece of cake. Do you have a set of small numbered drill bits?

--- End quote ---
No.  Where did you get yours?  One other question if I may?  Would it be possible to cure this idle problem by backing out the idle mixture screws a little?  Thanks!

77cruiser:
Got mine here.
https://www.mcmaster.com/#drill-bits/=1994gik

This looks to be a good source too.
http://www.micromark.com/mini-hand-tools/drill-bits-pin-vises
http://www.micromark.com/20-piece-Drill-Bit-Set-41-60
http://www.micromark.com/20-piece-Micro-Size-Drill-Bit-Set-with-Index-61-80

You'll need to buy both sets to get the range you need, unless someone else has a better source.

ykf7b0:
Thanks! 

ykf7b0:
To my surprise I was able to get the quadrajet to idle consistently by adjusting the idle mixture screws.  Later on and after the total break in is complete I will really get into the secondaries and see how it goes.

Navigation

[0] Message Index

[#] Next page

[*] Previous page