General Category > Quadrajet Carb Talk and Tips

Idle tube removal

(1/1)

Corey:
The tubes did not punch down without the collars so I tried propane plumbers torch with tip of a drywall screw to grab the tube with no luck, the screw wouldn't grab it.  Do I need to find an ultra tiny screw to thread into the tube?

Cliff Ruggles:
Use a .089" drill bit and drill the tubes down about 1/8" or so or just enough to get a good hold in them with a self tapping wood or drywall screw.  With a little heat against the casting they will come right out......Cliff

Navigation

[0] Message Index