« previous next »
Pages: [1]   Go Down

Author Topic: Edelbrock Secondary Air Flaps  (Read 2775 times)

Offline SundanceKid

  • Garage guy
  • **
  • Posts: 12
Edelbrock Secondary Air Flaps
« on: May 26, 2010, 12:06:43 AM »
Are the modifications Edelbrock made to the secondary air flaps on an 1910 worth the time to replicate? If so, does anyone have a 1910 and willing to take measurements? 
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: Edelbrock Secondary Air Flaps
« Reply #1 on: May 27, 2010, 04:19:31 AM »
Complete waste of time, we bend the tabs down and either add a notch at the POE holes, or relocate them under the flaps.....Cliff
Logged

Offline SundanceKid

  • Garage guy
  • **
  • Posts: 12
Re: Edelbrock Secondary Air Flaps
« Reply #2 on: May 27, 2010, 09:27:27 PM »
I've always used a small 1/8" notch (actually it's half a 1/8" circle).

Any benefit to a larger notch? Experience has taught me you can go too big. It has also taught me you can't remove the divider either (I lost a race I should have won trying that one).   
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: Edelbrock Secondary Air Flaps
« Reply #3 on: May 28, 2010, 02:38:29 AM »
The best scenario is always to relocate the holes under the flaps.  Large notches can produce a lean condition, the smaller the better.....Cliff
Logged
Pages: [1]   Go Up
« previous next »