Quadrajet Problem Solving > Diagnose a Quadrajet carburetor problem

Choke pull off opening too fast or air door spring too loose?

<< < (2/2)

CJK440:
Its a metal pull off that I drilled the orifice out. I then used a .019 drill to pop a hole in a piece of polypro paint brush handle and jammed it into the vacuum line.

I think the hole drilled too big because of the power drill and plastic melting. I then popped a clean .015 hole thru an ABS golf tee stem and tried that and the release time was dramatically slower.

No bog but it may open too slow now.

Cliff Ruggles:
I find drilling the restriction in pull-offs difficult and often near impossible.  I use a tapered reamer instead which provides infinite control vs drilling them with precision bits........Cliff

Navigation

[0] Message Index

[*] Previous page