« previous next »
Pages: [1]   Go Down

Author Topic: Spacer orientation?  (Read 1612 times)

Offline trymes

  • Newbie
  • *
  • Posts: 2
Spacer orientation?
« on: June 22, 2018, 01:33:26 PM »
I just got my carburetor back, and it came with a cardboard gasket/spacer that has plastic bushings for where the bolts go through. The plastic is flush with one side, but not the other side. Does it make a difference which side goes up?

Tom
« Last Edit: June 22, 2018, 01:52:08 PM by trymes »
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5435
Re: Spacer orientation?
« Reply #1 on: June 23, 2018, 05:01:22 AM »
No, those are just there to prevent over-tightening, not orientation of the gasket......Cliff
Logged

Offline steve s.

  • Garage guy
  • **
  • Posts: 15
Re: Spacer orientation?
« Reply #2 on: June 23, 2018, 04:17:00 PM »
You can center up those bushings with you fingers (if it bothers you).  They are just setting in the holes.
Logged

Offline trymes

  • Newbie
  • *
  • Posts: 2
Re: Spacer orientation?
« Reply #3 on: June 25, 2018, 06:20:19 AM »
Thanks, guys! I assumed it probably wouldn't matter, but I figured better to ask than find out the hard way that I was wrong.
Logged
Pages: [1]   Go Up
« previous next »