General Category > Quadrajet Carb Talk and Tips

7045213 project

(1/1)

Sonny:
Picked up a new project carb recently. Codes are 7045213, YA, date 0095.

It appears to have been freshly rebuilt before it was hidden in a box on a shelf my father's shop.

I don't think it has the factory configuration, though. Can I get a sanity check on the measurements, please?

* Metering Rods: primary 46 (not marked B, so assume they're A); secondary DA
* Main jets: 71
* Idle circuit: upper air bleeds .0935, lower air bleeds .0635, idle tube jet .039, DCR .063, bypass air .096
* Mixture screw holes: .089
* Accelerator pump discharge holes: .026
* Main circuit: upper air bleeds  .0465, lower air bleeds .0465
* The APT is in the base plate and it is exposed.

Cliff Ruggles:
Most likely its been commercially "remanufactured" not "rebuilt".  Those sizes are not correct for that carb number as far as main airbleeds, jets and metering rods.......Cliff

Sonny:
Thank you Cliff. This may be one of those lessons in humility you have written about here on the forum. I will give it a closer inspection to see if it has any of the other changes common to remanufactured units.

Navigation

[0] Message Index