General Category > Lobby
Welcome to the web's first Q-Jet only Forum!
1QIKTA:
Cliff,
Great Idea...Between this,the holidays and the lift install you have been a busy man!! I am sure '09 will be good to you!!
All the best,
Jay
Cliff Ruggles:
Thanks Jay. Also thanks to all those who signed up recently.
We did a major clean-up in the shop over the holidays, and installed a new shop lift. I had some minor surgury planned, still recovering from that, with a few minor complications, but nothing serious.
Looking forward to another great year, lots of good things in the works, including some camshaft testing with our new engine, and building a 455 for a good friends car with ported iron heads and upgrading to a roller cam. Hoping for some low 11 second runs out of it, it was running low 12's with unported heads and a flat hydraulic camshaft.
I'm also going back to the factory iron intake on my engine, so see how it compares to the Edelbrock RPM intake that we are currently running?
We are also upgrading our parts inventory with lots of new stuff. Also adding more items to our custom HP rebuild/recalibration kits.
Happy New Year!!......Cliff
sawdusty:
HI Cliff, just found your site got a few ? I have a quadrajet carb when I got it, it was in a few pieces. first of all the numbers on it are 7028219 DG can someone tell me what application it goes on? I think its a 68 chevy but what size motor? I bought a basic kit for it when I took the top plate off there are only two brass tubes (idle tubes) and no secondary feed tube I compared it to a later model that I have . Does this model only have two or am I missing them? thanks for any help and I think Iam missing some of the choke parts I might send it to you so you can make sure its going to work right thanks again Jerry ps I bought some 48 pontiac heads off you a couple of years ago
Cliff Ruggles:
It's a 1968 Chevy carburetors.
The two missing tubes were for the POE system, which wasn't used on many 68 Chevy models for some reason? The POE system can be added during rebuilding, we do it to all 68 and earlier carburetors that didn't use it.
The two tubes that remain are not idle tubes, they extend into the secondary fuel supply passages and add some emulsion air to that system.
The idle tubes are the same as all other q-jets, pressed into the main body toward the front of the casting.....Cliff
465Tony:
Hello Cliff,
Your Echo guru here, Like the forum setup.
That 465ci motor you helped me with is now fully assembled, check back with you next week.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version