« previous next »
Pages: [1]   Go Down

Author Topic: drill and tap size for broken primary air flap screw  (Read 910 times)

Offline stevef

  • Carb lover
  • ***
  • Posts: 80
drill and tap size for broken primary air flap screw
« on: September 09, 2022, 10:45:41 AM »
Even though I ground off the tips of those tiny primary throttle shaft air valve screws before unscrewing them, one of them broke off in the shaft anyway. Can anyone tell me what size drill bit and tap I'll need? Thanks!
Logged

Offline Kenth

  • Jet Head
  • ****
  • Posts: 432
Re: drill and tap size for broken primary air flap screw
« Reply #1 on: September 09, 2022, 12:22:06 PM »
#47 drill and 3-48 tap.
Logged

Offline stevef

  • Carb lover
  • ***
  • Posts: 80
Re: drill and tap size for broken primary air flap screw
« Reply #2 on: September 09, 2022, 02:02:09 PM »
Perfect. Thanks very much for your quick reply! 
Logged

Offline Mr.Pontiac

  • Qjet Hero
  • *****
  • Posts: 544
Re: drill and tap size for broken primary air flap screw
« Reply #3 on: September 10, 2022, 08:31:39 PM »
I bought 5000 by mistake 3/16 long, selling by 50 pieces for 5.00$
Logged
Pages: [1]   Go Up
« previous next »