General Category > Quadrajet Carb Talk and Tips
TV cable to early Quadrajet
old cars:
Install pin as in picture. You will have to be accurate though
Kenth:
No need for an added stop on sec shaft if pri to sec is properly adjusted.
1. When rod meets lever, (yellow),
2. rod is in center of hole in lever, (orange). To adjust, bend rod, not lever.
3. Then adjust closing of secondaries, (green).
4. And last adjust for proper sec blade opening angle, (blue).
Also, not only M4M Truck Qjets uses the tall lever on pri shaft for the sec rod, f.e. late 70´s Olds Car M4M Qjets uses these too.
tayto:
Ok thank you! I will get carb back from friend and recheck
Cliff Ruggles:
Marine Q-jets use different linkage than shown in the pic. Simply set them up to fully open and if you want to insure they always stop at the same point you can gently bend the front tab so it contacts the bottom of the link at the exact same moment....they aren't fussy and it will come to the same full open point each time you go to WOT......
old cars:
I should Apologize for a previous post with 1970 GTO carb. Those numbers were after I made adjustments. Sorry for the confusion.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version