General Category > Quadrajet Carb Talk and Tips

Are these holes in the secondary down tubes okay?

(1/2) > >>

stevef:
This q-jet from an Olds, #17057256, has 2 holes drilled through on both of the secondary down tubes, like in the pic. I saw in Cliff's book that extra holes in those tubes might not be good, draining the bowl too quickly. Both tubes appear to be drilled the same way, so wondering if it might be factory. Should I replace them with undrilled ones? If so, do they just pull out and press in?

qjetsrule:
Use a heat gun to warm up the casting to help loosen the tubes.

stevef:
Thanks for the tip!

quadrajam:
I agree, And use some red loctite on the new tubes, then use a small sharp
center punch to dimple/stake the casting around the tubes. This will tighten
up the holes grip on the tubes.

stevef:
Thanks!

Navigation

[0] Message Index

[#] Next page