Author Topic: WOT Stumble  (Read 1143 times)

Offline Chevynation

  • Carb lover
  • ***
  • Posts: 51
WOT Stumble
« on: October 21, 2022, 08:34:24 PM »
Hello, my Quadrajet is part number 7040203 and I’m familiar with mechanical secondaries carbs and this is my first Quadrajet. If I got WOT the car will respond and then kick in which I’m assuming is the secondaries opening up. I have a 4-speed so when I shift through gears it will fall and then pick up almost similar to how a turbo car starts to pull on the big end. Is this normal for a Quadrajet or do I need to adjust the airvalve? Thanks.

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: WOT Stumble
« Reply #1 on: October 24, 2022, 08:20:56 AM »
Check/test the opening rate of the secondary pull-off.  It should open in about 1.5-2 seconds if compressed and released.

The tension of the secondary air flap spring is also a player.  It should be set about 3/4 turns from when it just touches the pin for initial testing.

I see a LOT of weak/defective springs that have been wound to tight and bad secondary plastic cams.  Both need to be in good working order to get the best results......