« previous next »
Pages: [1]   Go Down

Author Topic: wings on my base gasket  (Read 336 times)

Offline guero_gordo

  • Garage guy
  • **
  • Posts: 6
wings on my base gasket
« on: February 20, 2025, 02:53:30 PM »
I'm 75% sure this is from the rebuild kit I bought from Cliff
In any case, what do the flaps in the secondary bores on this gasket do, and should I just hack them off?

7040511 on sbc350 gen I
Logged

Offline 77cruiser

  • Qjet Hero
  • *****
  • Posts: 644
Re: wings on my base gasket
« Reply #1 on: February 20, 2025, 04:29:15 PM »
Looks like it's backwards.
Logged
Jim

Offline guero_gordo

  • Garage guy
  • **
  • Posts: 6
Re: wings on my base gasket
« Reply #2 on: February 21, 2025, 09:52:00 PM »
Well, them small holes are in the front, and the big'uns in the back...
Logged

Offline Kenth

  • Jet Head
  • ****
  • Posts: 497
Re: wings on my base gasket
« Reply #3 on: February 22, 2025, 04:24:42 AM »
It is clear that the gasket is installed in the wrong direction.
Logged

Offline guero_gordo

  • Garage guy
  • **
  • Posts: 6
Re: wings on my base gasket
« Reply #4 on: February 23, 2025, 07:52:41 PM »
Four holes that perfectly match the holes in the carb and manifold, except for the quarter-moon protrusion into the secondaries, and orientation of the gasket is the problem here?
Logged

Offline Kenth

  • Jet Head
  • ****
  • Posts: 497
Re: wings on my base gasket
« Reply #5 on: February 24, 2025, 12:46:04 AM »
Yes.
Logged

Offline quadrajam

  • Carb lover
  • ***
  • Posts: 127
Re: wings on my base gasket
« Reply #6 on: February 24, 2025, 11:22:35 AM »
I tried to tell Cliff those winged gaskets werent gonna go over very well........

Guero, pick up the phenolic spacer and turn the gasket around and set
the spacer straight back down. Then  post another picture of it.

If all else fails use a 4 hole gasket.

QJ
Logged
Pages: [1]   Go Up
« previous next »