General Category > Quadrajet Carb Talk and Tips

Main Well Bleed Tubes

<< < (3/3)

kelley555:
Omaha, you're right the restriction is at the bottom of the tube & it doesn't measure the same size(in thousands)as the top of the tube. This will throw you a loop,cause you need a 2" long bit to measure the tube when installed or I used a set of long tip cleaners to get down there. I should have measured the tubes Cliff sent before I installed them,but I didn't.I thought about it & got a set of tip cleaners out & measured the restriction at the end of the tube.Later Kelley

Navigation

[0] Message Index

[*] Previous page