General Category > Quadrajet Carb Talk and Tips

Changing the choke pull-off from the rear to the front

<< < (3/3)

Cadman-iac:

--- Quote from: novadude on November 14, 2025, 04:56:29 AM ---Nice work!

--- End quote ---

 Thanks, the donor for the aluminum I used was the base plate off of an electric Dual-jet. Why not, right? A hacksaw, a couple of files, and a piece of sandpaper and its done.
 My first attempt was too thin and it cracked when I installed the adjustment screw. My mistake was in not threading the hole all the way through.  I tried to leave just a half a thread uncut for resistance so that the screw would hold its position.
 This one is threaded all the way and I just used blue Locktite to keep it from moving.

novadude:
Great idea.  Looks professional.

Cadman-iac:
   Was just looking through the old threads and found this on the subject. I had to screenshot it, so it's posted below.

Navigation

[0] Message Index

[*] Previous page