« previous next »
Pages: [1]   Go Down

Author Topic: Copper on gaskets?  (Read 2408 times)

Offline Toronado

  • Carb lover
  • ***
  • Posts: 113
Copper on gaskets?
« on: March 31, 2011, 02:32:58 PM »
Was just reading about a product claiming its designed for
gaskets and for carb gaskets to.

 They claim it fills gaps irregularities, and prevents burn out,
any one every try this copper spray that goes on gaskets.
I think the concept sounds good for slightly leaky carbs,
you could spray the area that leaky to give it more sealing area.

(Permatex/9 oz. aerosol can Copper Spray-A-Gasket hi-temp adhesive sealant)
Logged

Offline Schurkey

  • Carb lover
  • ***
  • Posts: 157
Re: Copper on gaskets?
« Reply #1 on: April 03, 2011, 10:39:11 AM »
What happens to all the little copper particles that DON'T get trapped between the castings?

"I" would not want them floating around inside my carb.
Logged
Demand compensation from Communist China for the damage done by the Virus Originating in the Wuhan Lab, released (intentionally or negligently) into the world in 2019 (VOWL-19).  Trillions of dollars, plus direct compensation to individuals for medical bills, and "wrongful death" settlements.

Offline Toronado

  • Carb lover
  • ***
  • Posts: 113
Re: Copper on gaskets?
« Reply #2 on: April 04, 2011, 12:32:50 AM »
You not suppose to use it directly on the carb itself.
Its designed to be used on the gasket and allowed to bond to it
before installation.
 Supposedly it has a good adhere ability and
pieces don't just fall off.
I figure i will do some testing with it,
because copper is actually one of the best gasket material around ;D.
Logged

Offline billy 2

  • Carb lover
  • ***
  • Posts: 50
Re: Copper on gaskets?
« Reply #3 on: April 04, 2011, 07:50:40 PM »
The only time  i used the copper spray was on the thin metal head gaskets as a extra sealent.  billy 2
Logged
Pages: [1]   Go Up
« previous next »