Quadrajet Problem Solving > Diagnose a Quadrajet carburetor problem

Quadrajet fuel bowl level and leaking fuel..

<< < (2/2)

Schurkey:

--- Quote from: cecil07 on April 27, 2011, 08:16:42 AM ---I noticed on my last tear down... the clip/pin that the float balances on, sits a little higher than the main body... so when the top plate is installed it pushes down and alters the float reading somewhat... i pinched the clip together alittle... so now its atleast flush with the main bowl...will try this out and post back...

--- End quote ---
I do exactly the opposite.

I deliberately pull the clip apart, so that the air horn presses on the top of the clip and holds it securely in position.

Shouldn't affect the float height at all, the float pivots on the bottom of that clip, which is secured on each end by the main body casting.

Navigation

[0] Message Index

[*] Previous page