Quadrajet Problem Solving > Buy Quadrajet Parts, Quadrajet Kits, Service

secondary hanger hieght guage

(1/2) > >>

leroy:
First time poster long time lurker based in Western Australia

Own a 73 corvette 454 4 speed

Have read your book a few times now have a working carb plus another i am ripping parts off

Cliff have you thought of producing your guage to enable us to buy to play with different hanger hieghts or is there a chart somewhere to read

If there is is it measured from the base of the hanger or from inside edge where the hanger sits on the carrier to the holes   

Cheers

Cliff Ruggles:
Many years ago (at least 25), I made a gauge from a piece of flat steel.  I drilled holes for the "B" hanger, "G" hanger and "P" hanger.  These days I don't look around for different ones, I just gently bend what I've got to fall in where I want it.....Cliff

leroy:
Hi Cliff

Yes I remember reading this in a previous thread hence the question

CAn you reproduce these for sale or direct me to a table that givees these hieghts along where exactly to measure to and from

Cheers

leroy:
ok bit of searching found you measure between inside hanger where it sits on the carrier that rides the cam connected to the airflap to the hole for the rods

B hanger is 520 thou

G hanger is 545 thou

P hanger is 590 thou

gotta love google

so there you go should of checked first i guess b4 posting the ? 8)

leroy:
Righto apologies to Cliff

 should of read the edelbrock section in the quadrajet bible more closely

pg121  a pic of the spec sheet for calibration kit and guess what?

measurements for the hangers and where to measure ::)

Soo not  hard to make up my own gauge ;D

Navigation

[0] Message Index

[#] Next page