Quadrajet Problem Solving > Diagnose a Quadrajet carburetor problem

Engine continuously stalls until hot.

<< < (2/2)

Cliff Ruggles:
1977 California carburetor.  Pretty lean carburetors for what you are doing.  Sounds like it wants more fuel just about everywhere.  Any idea how it is set-up?.....Cliff

Schurkey:

--- Quote from: BPOE1975 on December 17, 2011, 07:06:58 AM ---When cold, engine will fire and run a few second then stall.  Does this continuously until it is hot then it runs fine.  Even if I hold throttle at 2000 rpm is will start stumbling and stall.  Choke flaps close when I tap the throttle.  Adjusted choke pull off to 3/16 inch.  Adjusted coil to be rich and comes off when thermostat opens. When it fires the flap goes way beyond where I set the pull off.  This engine vacuum pulling flaps open?
--- End quote ---
What's the fast idle speed?

I would expect the choke coil would have released the choke LONG before the thermostat opens.

3/16 seems "rich"; but it could be correct for your carb.

Any chance the engine is dying from too much fuel instead of too little?

Navigation

[0] Message Index

[*] Previous page

Go to full version