Quadrajet Problem Solving > Buy Quadrajet Parts, Quadrajet Kits, Service

Plating

(1/3) > >>

Ethan1:
 Cliff,
 What type of plating do you do? I know you do plating for the main housing and airhorn. Do you also do plating for linkage parts too? How much does that usually run to do all linkage?

 Thank you,
 Ethan

73ss:
Hi,
Was going to give a call after the holidays with some plating questions as well. Do the choke & secondary flaps get plated?
Does the choke flap & shaft need removed from airhorn?
Do the tubes need removed from airhorn prior to plating?

Thanks

Ethan1:

--- Quote from: 73ss on December 24, 2011, 02:25:59 PM ---Hi,
Was going to give a call after the holidays with some plating questions as well. Do the choke & secondary flaps get plated?
Does the choke flap & shaft need removed from airhorn?
Do the tubes need removed from airhorn prior to plating?

Thanks

--- End quote ---

 73ss,
 I see he does electroplating to the smaller parts.

 I have a nother question, to add to ours.

 I have a hard to find part on my Qjet. It is almost like a rear choke pull-off. Will electroplating effect the plastic part of it, Cliff? Also, do you do the same for the flaps/butterflies?

 Thank you,
 Ethan

Cliff Ruggles:
Pic of a finished unit showing the plating process that we use here.  The main casting and airhorn are zinc/chromated, the small parts are electroplated.

We charge $45 to do a main casting and airhorn, $125 for the whole deal......Cliff

Ethan1:

--- Quote from: Cliff Ruggles on December 25, 2011, 01:37:09 AM ---Pic of a finished unit showing the plating process that we use here.  The main casting and airhorn are zinc/chromated, the small parts are electroplated.

We charge $45 to do a main casting and airhorn, $125 for the whole deal......Cliff

--- End quote ---

 Cliff,
 Would the electroplating effect plastic? I have a hard-to-find part on my Cadillac carb and part of its plastic. The rod and bracket needs to be replated and there attached to the part. I cannot remove the bracket and rod linkage without destroying the plastic part. That is why I'm wondering if the electroplating would effect it.

 Thanks.

Navigation

[0] Message Index

[#] Next page