« previous next »
Pages: [1]   Go Down

Author Topic: continental torque converterCliff,  (Read 2717 times)

Offline Paul

  • Carb lover
  • ***
  • Posts: 69
continental torque converterCliff,
« on: February 23, 2012, 06:34:35 PM »
Cliff, The guys at Pontiac street performance said you could set me up with a continental torque converter for my car. Its for a TH-400 tranny powered by a Pontiac 1974 455 bored 30 over thats going into a 1977 Pontiac Trans-Am .  the cam is a Comps XE284H.  C.R. is going to be around 9.5:1 rear gears are 3:42, the car is just going to be a weekend driver. Will the flex plate mounting holes , in the converter  come drill and tapped? Will it need a special flexlate? Any help would be appreciated! Thank You.

Paul
Logged

Offline jamesF

  • Global Moderator
  • Carb lover
  • *****
  • Posts: 171
Re: continental torque converterCliff,
« Reply #1 on: September 20, 2012, 01:59:17 PM »
This is almost the same setup I have. I put Cliffs recommended 13" Continental Pontiac Special in my car and it works much better then the Hughes I had.. That one worked well but this one grabs hold much faster...
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5435
Re: continental torque converterCliff,
« Reply #2 on: September 25, 2012, 05:02:55 AM »
Correct, we have been a dealer for Continetal converters for over 10 years.  When you get time, call the shop and we'll get what you need headed your way...thanks...Cliff
Logged
Pages: [1]   Go Up
« previous next »