Cliff's Quadrajet Parts and Rebuild Kits

General Category => Quadrajet Carb Talk and Tips => Topic started by: Dark T/A on October 14, 2012, 05:22:03 PM

Title: Bent my primary metering rod arm
Post by: Dark T/A on October 14, 2012, 05:22:03 PM

in the process of tearing down my carb and following Cliff's book. I tried to be as careful as i could but manage to pry too much and one side of the piston and is now tweaked. What do I do replace it or bend it back??

Title: Re: Bent my primary metering rod arm
Post by: Shark Racer on October 14, 2012, 08:31:13 PM

Bend it back, just take some measurements to make sure the eyelet of each arm is roughly the same distance to the bowl or other reference points.

Title: Re: Bent my primary metering rod arm
Post by: Dark T/A on October 15, 2012, 07:56:58 AM

thanks its not too bad shouldnt take much