Cliff's Quadrajet Parts and Rebuild Kits
Quadrajet Problem Solving => Buy Quadrajet Parts, Quadrajet Kits, Service => Topic started by: Mr.Pontiac on January 26, 2013, 06:31:31 PM
-
The brass tubes in rear of carb. i call em emulsification tubes, i heat carb. up to pull em out and they get stubborn sometimes, how do you remove them??? I see you can buy brass stock tubes same o.d and i.d. but using a tubing cutter always leaves a burr, are you doing this also???
-
If you get a burr, head over to a good gun shop, they sell deburring tools or reloaders that will put a nice clean chamfer on them for a couple of bucks.
-
Never once had any trouble pulling them out with a small pair of wire cutters. I warm up the casting around them for a few seconds with a propane torque. Since we change the plastic cam on all builds, no risk of melting it....Cliff
-
Thats what im using but always gets a tiny burr close to the casting area, no biggy just wondering.