Cliff's Quadrajet Parts and Rebuild Kits

Quadrajet Problem Solving => Diagnose a Quadrajet carburetor problem => Topic started by: FORREST MILLER on October 06, 2008, 12:02:59 PM

Title: replacing bushings
Post by: FORREST MILLER on October 06, 2008, 12:02:59 PM

Hi Cliff, I just replaced the primary shaft bushings in my carb, and the clearance between the new bushing and shaft is .004". Is this OK, or should I be looking for a tighter clearance. ( Bushing measures .312", Primary shaft measures .308")

Thanks.....Forrest

Title: Re: replacing bushings
Post by: Cliff Ruggles on October 21, 2008, 04:29:23 AM

Forrest, .004" clearance is fine, they weren't that tight from the factory......Cliff