Cliff's Quadrajet Parts and Rebuild Kits

General Category => Quadrajet Carb Talk and Tips => Topic started by: 77cruiser on November 26, 2015, 06:05:33 PM

Title: Removing outer boosters
Post by: 77cruiser on November 26, 2015, 06:05:33 PM

I have a carb from a Cad. & it's got the aux. power system & aneroid valve, so I was going to try & set it up by removing the outer booster rings.
Where would I expect to star with jetting, I think I'm going to try it on the jets only, maybe both ways I don't know.
But it does have the primary POE system so that's something else too.
Just something to try, might be a waste of time but that's what this hobby is for right?

Title: Re: Removing outer boosters
Post by: Cliff Ruggles on November 30, 2015, 05:45:04 PM

Not enough information. 

Are removing the aux pp?

Stock airlbeed sizes?

Using or not using the primary POE?

Title: Re: Removing outer boosters
Post by: 77cruiser on December 01, 2015, 06:20:42 PM

Was thinking of blocking the aux. PP.
Probably stock sized bleeds or should they be smaller to help the primaries to start up sooner?
If there's an advantage to use the POE.

Title: Re: Removing outer boosters
Post by: Cliff Ruggles on December 03, 2015, 04:20:24 AM

No advantage using APT for that type of project.  I'd leave the airbleeds at the smaller sizes.....Cliff