Cliff's Quadrajet Parts and Rebuild Kits
General Category => Quadrajet Carb Talk and Tips => Topic started by: Chief1010 on February 27, 2016, 01:40:30 AM
-
In the process of rebuilding my Qjet, and decided to take a dremel with a wire brush on it to clean it up alittle.. The 1 small corner I cleaned it took the greenish color off the carb and took it down to bare metal.. I stopped right there because I'm not sure if that is a protective coating or not.. I'm sure some fine folks on here know this answer..
-
In the process of rebuilding my Qjet, and decided to take a dremel with a wire brush on it to clean it up alittle.. The 1 small corner I cleaned it took the greenish color off the carb and took it down to bare metal.. I stopped right there because I'm not sure if that is a protective coating or not.. I'm sure some fine folks on here know this answer..
What part of the carburetor did you take the finish off of? Linkage? If so, that does have the Teflon coating that the factory put on it, to protect it from corrosion.
-
scrubbing any of it with wire brush will take the finish off. Any harsh chemicals will also pull color off the main body and air horn. Use some carb cleaner liquid or spray.
-
It was a small section at the bottom of the base.. I didn't know they used Teflon as a coating on these carbs... Thanks for the info..
-
It was a small section at the bottom of the base.. I didn't know they used Teflon as a coating on these carbs... Thanks for the info..
Only on the linkage. Like primary and secondary throttle shafts, accelerator pump arm, choke and accelerator pump linkage. As Carman noted above, the air horn and fuel bowl are zinc chromated, which give it a green hue. Base plate is bare aluminum.
-
What is a good polish to use to make it look alittle better.. I know you can have them replated.. Just thought maybe there was a cheaper more at home process you could use to brighten it up.. Thanks again..