Cliff's Quadrajet Parts and Rebuild Kits
General Category => Quadrajet Carb Talk and Tips => Topic started by: gokitty on February 23, 2017, 04:16:34 PM
-
My 67 7027262 carb body crumbled. Located a good 67 7027262 body. Carb now rebuilt using the original top and bottom together with the replacement body. The crumbled body has a good,round 70262 tag that I would like to safely transfer to the "new"carb and securely fasten it to the host carb body. Any suggestions as to the best way to do this? Thanks!
-
They can be very difficult to remove w/o damaging them. Not sure if there is a good way or not as they are staked in several places to retain them.
I've managed to remove a few without tools by blowing compressed air into the little hole in the center, just make sure it doesn't fall down behind the work bench. We lost one a few years ago using that method and never did find it......Cliff
-
Thank you,Cliff. The tag is going on a body which had an inlet repair you did for our friend Mike in Texas in November/December '17.
-
Oops!Happy fingers on the keyboard. "Mike" should read as "Mark".
-
My 2 cents worth if i may, take a very pointed scribe and pull enter up ever so slowly, then lay a rag over it then pump the air to it.