Cliff's Quadrajet Parts and Rebuild Kits

General Category => Quadrajet Carb Talk and Tips => Topic started by: fumehappy on May 18, 2017, 08:31:19 AM

Title: Anyone know what these are for? Received a Cliff's Rebuild kit.
Post by: fumehappy on May 18, 2017, 08:31:19 AM

Hello,
I ordered one of the rebuild kits from here, and while disassembling my quadrajet for cleaning I figured out where all the parts go... except for this bag of washers.  This is my first rebuild, so if someone could point me in the right direction, that would be extremely helpful.
Quadrajet is off an 84 Chevy C10.  I can provide the numbers if needed.
Thanks!
(http://i12.photobucket.com/albums/a238/fumehappy/washers_zpsokrkvt9s.jpg)

Title: Re: Anyone know what these are for? Received a Cliff's Rebuild kit.
Post by: Ethan1 on May 18, 2017, 11:35:46 AM

 The white tube is the vacuum tube for the hot air choke (if equipped). The large white washer looks like the one that goes on first than the fuel inlet nut. The two black washers are I believe the choke shaft seals. Not sure where the other three go?

Title: Re: Anyone know what these are for? Received a Cliff's Rebuild kit.
Post by: 77cruiser on May 18, 2017, 03:30:19 PM

Green might be accel. pump stem seal & the roll pin for the pump lever.

Title: Re: Anyone know what these are for? Received a Cliff's Rebuild kit.
Post by: blazer74 on May 18, 2017, 04:41:03 PM

looks like your acc pump check ball there too.