Cliff's Quadrajet Parts and Rebuild Kits

Quadrajet Problem Solving => Quadrajet Parts and Numbers => Topic started by: 4ever18 on February 16, 2019, 04:15:49 AM

Title: QuadraJet Choke Pull Off Bracket Repair
Post by: 4ever18 on February 16, 2019, 04:15:49 AM

I have a couple of choke pull off brackets and the tabs that hold the pull off to the bracket have been broken off.  I ordered a wire repair clip from QuadraJet Parts. com but the part was out of stock and they don't know if or when it may be restocked.  Any idea where else I may be able to find this part?

Title: Re: QuadraJet Choke Pull Off Bracket Repair
Post by: Cliff Ruggles on February 26, 2019, 04:54:16 AM

I don't have any left in stock and just make them if/as needed from spring wire (duration spring for our accl pumps).

I checked with our suppliers and they are out of stock on them and have been for some time.  It's not really a difficult part to make, basically just a wire retainer when the arms are broken on the bracket.....Cliff

Title: Re: QuadraJet Choke Pull Off Bracket Repair
Post by: 4ever18 on February 27, 2019, 04:13:46 AM

Excellent.  I'll give it a try.  Thanks!

Title: Re: QuadraJet Choke Pull Off Bracket Repair
Post by: Cliff Ruggles on February 28, 2019, 03:11:00 AM

I've made a few here recently out of the spring wire used on our accl pumps.  Just takes a few minutes to straighten out the wire and bend some ends on it to go into the holes on the bracket and retain the pull-off at the same time.......Cliff