Cliff's Quadrajet Parts and Rebuild Kits

Quadrajet Problem Solving => Buy Quadrajet Parts, Quadrajet Kits, Service => Topic started by: 68rs/ss on September 05, 2020, 07:08:28 PM

Title: 3x2 on SBC
Post by: 68rs/ss on September 05, 2020, 07:08:28 PM

First off, I realize this is a Q-jet site. Was curious if your shop has done any Rochester 3x2 set-up's on a sbc. I suspect, some parts would be the same as Q-jets. Other than the cool factor, would there be any drivability or performance advantages to the 3x2 set-up over a lone Q-jet? Phil

Title: Re: 3x2 on SBC
Post by: Cliff Ruggles on September 06, 2020, 02:33:17 AM

Haven't done any Chevy's, but have restored quite a few Pontiac, Olds and Cadillac tri-power carburetors over the years but don't offer that service at this time. 

They are extremely labor intensive and lots of parts to zinc plate.  I also make my own fuel  lines for them in most cases as I'm never happy with the original lines or the aftermarket line sets being sold for them......Cliff

Title: Re: 3x2 on SBC
Post by: 68rs/ss on September 07, 2020, 06:23:25 PM

Thanks for the reply. I guess I will stick with the Q-jet. Works well. Been seeing a few 3x2 retro set-up and was curious if it might be something to try. Phil