Cliff's Quadrajet Parts and Rebuild Kits
Quadrajet Problem Solving => Dialing in your rebuilt Quadrajet carburetor => Topic started by: Mr Hand on April 09, 2022, 10:38:28 AM
-
Have a 17057204 on top of a stockish 350 sbc. Just has headers and a free flowing exhaust, four speed car too.
Currently has 76 jets, 52K rods and CH secondary rods.
Other than running pig rich it performs ok although I have not really done any full throttle blasts.
I attribute some of the richness to the idle mix screws being cranked out maybe to compensate for a very worn throttle shaft causing a big vacuum leak. Engine is a bit tired but still pulls 19" of vacuum.
I am rebushing the base plate to fix the vacuum leak issue but what other things need to be done to this stock carb before going back together?
Is the 52/76 jet/rod combo ok to use as is? I have a new pair of 78 jets but I am thinking that may be too rich? I have the APT plug tapped out to do some fine tuning later but I am curious what else I should do while it's apart.
-
Nice unit but pretty lean in stock form, not rich. Sucking air around the throttle shaft would only make is leaner and smell more in the exhaust, not rich.
I would NOT install larger jets, instead I'd recommend using my full tapered 45 primary rods and smaller jets, plus one of my rebuild kits with a high flow N/S assembly and lifetime warranty accl pump. It will enjoy opening up the idle system just a tad even for a stock engine build.
When you get time call me at the shop, I'm here 7am-4pm, Monday thru Thursday EST.....tks.....Cliff