Cliff's Quadrajet Parts and Rebuild Kits
General Category => Lobby => Topic started by: oliver1232 on April 24, 2025, 03:46:47 AM
-
My "budget" build street strip
Engine
1969 Pontiac 428. 2 bolt main block 4 bolt pre drilled from factory 4 Bolt mains added
Specs:
Bore .40 over 436 CI KRE Keith Black light weight piston versions 10CC I think!
H beam eagle rods stock 428 length
Rockers 1.65 Butler performance roller Tip
Lifters Morrell Hydraulic rollers
Compression 10-5-1 ?
4 Bolt Billet KRE Mains and end caps Line Honed Block pre drilled
HEADS KRE 310 Ported heads Ferrara 5000 versions large HR springs
KRE FLOW NUMBERS
INTAKE SIDE EXHAUST SIDE
.100 88 .100 53
.200 165 .200 116
.300 216 .300 156
.400 278 .400 181
.500 299 .500 197
.600 308 .600 209
.700 312 .700 218
CAM KRE HR 242 CAM
Adv. duration 296/307
.050 duration 242/248
Lobe sep. 112
.544/.546 lift w/1.5 rocker I went with 1.65 rockers 598 lift/600 lift to maximize ported head flow usage
Intake and Fuel delivery
Port Matched TQ 2 intake and Edelbrock Pro flow port injection. Kit comes with 35lb injectors unlike chevy guys Pontiac guys have to pay extra for the 45lb injectors I did this as they support the upper power levels
Distributer is what comes in the proflow kit
Exhaust Doug's headers 2.5 inch exhaust "quiet" flow master FX mufflers however I have the valve operated Header DUMP exhaust bypass so right out the headers it goes..
Timing chain and all other accessory's are stock
Transmission TKX
Rear 72 Buick upgraded Moser 30 spline axels Eaton Detroit Locker worm gear unit with 3:73 Ratio
ARP bolts rear cover with main bearing CAP supports rear disk conversion, Strange pinion yoke with Ubolt upgrade 3150 U joints/ Had to get a frame brace kit for the 1967 GTO as the frame on A body's is a little flexi weak...
What power levels do you think I can reach...?
Looking forward to hearing from cliff as he was the inspiration of this build having the only hard data 428 build on the internet with respect to power and aftermarket heads, I put my own spice on mine they are close not exact... don't want to wear another man's boots after all..
Thoughts critics are WELCOME
-
Motor and car should be done end of JUNE 2025 - its at the machine shop now. so any changes this is the time.
-
Test
-
I'll say 580 @ 6500.
-
I'll say 580 @ 6500.
I was worried about the cam being over sized my specs are similar to cliffs and he went with a lower @ but much more lift ... I have made an adjustment for that once I had concrete flow numbers to adjust for..